Recently, the Technical Standards Institute of the Ministry of Knowledge Economy of the Republic of Korea announced that it will prepare and publicize safety standards (cases) for LED fluorescent lamps (converter appearances). The safety standards to be publicized will include D12 sockets, LED fluorescent lamps and LEDs based on LED fluorescent lamps. Four standards such as fluorescent converters.
The structure of LED fluorescent lamps is mainly divided into three types: one is to install a ballast inside the existing fluorescent lamp; the other is to remove the ballast and add an LED dedicated converter externally; the third is to directly connect the power supply to the LED lamp. . In order to prevent mixing with ordinary fluorescent lamps, the external LED fluorescent lamps mainly adopt two design methods: one is to use a dedicated base; the other is to isolate from the bottom of the ordinary daylight lamp. However, when the LED conversion device is mixed with the fluorescent lamp, problems such as lamp damage and ballast heating often occur.
The safety standards for converter-type LED fluorescent lamps of the Technical Standards Institute of the Ministry of Knowledge Economy of Korea mainly have the following characteristics:
First, the LED fluorescent lamp with special bottom support, its bottom support and shape are different from ordinary fluorescent lamps, which fundamentally eliminates the mixed phenomenon.
Second, the two ends of the LED fluorescent lamp are isolated from the power interface, and the power interface is set at other parts of the lamp.
3. Connect the power supply from one end of the LED fluorescent tube. The safety of this design is still being tested, and if the safety is approved, it will be certified.
The Korea Technical Standards Institute will establish safety standards in terms of safety detection methods and provide support for the market development of LED fluorescent lamps. The safety standards for high-quality external transformations will also be used as an important basis when setting standards. At present, the main performance of LED fluorescent lamps is that the beam can reach more than 2100 lm, the light efficiency can reach above 90 lm/W, and the beam maintenance rate is above 90%. It is possible to raise these standards in 2011.
·Basic precautions
Do not put expensive oil into low-quality cartridges to avoid wastage. Most pre-filled oil cartridges have the so-called 510 thread. The oil cartridge screws onto a rechargeable battery. Some of these batteries have buttons and some heat up automatically when you pump the oil. Some batteries have multiple temperature settings and some heat up to a preset temperature; these features need to be known in advance.
·Cleaning notes
Use a suitable cleaning tool to clean them, such as activated charcoal or dried tea leaves in a used pipe to absorb the oil. It is important not to use alcohol or other boiling water to clean the pipe, and to wait until it has cooled down completely before cleaning. Otherwise, the hot stem will come into contact with the watery liquid and cause the mouthpiece tenon to loosen, thus shortening the life of the 510 cartridges.
This is what you should be aware of when using 510 cartridges. At the same time, when using 510 cartridges, there are still some vaping tips, for example, when using them, be careful not to suck too hard, will not produce smoke. When you inhale too hard, the smoke is sucked directly into your mouth and not atomized by the atomizer, so gently inhaling is more powerful and gives you a better vaping experience.
510 Cartridge Oem,Leakproof 510 Cartridge,510 Battery And Cartridges Oem,510 Cartridge
Shenzhen MASON VAP Technology Co., Ltd. , https://www.e-cigarettefactory.com