Xingu Moparty RGB Fan Kit Unpacking

Reasons to purchase

With the release of the 2 Series motherboard, it was felt that playing lights became the new DIY direction. . . So I also came in for a play

Currently relatively cheap, relatively early in the morning, there are Qiao Sibo FR-531 12CM chassis fan RGB fan three fan set

JONSBO FR-531 12CM Chassis Fan RGB Fan Three Fan Set (12CM/LED RGB 256 color light fan) 99 yuan Jingdong direct link

X East has been 99, controller up to 3 fans, the lamp is in the bearing, be regarded as more distinctive, but I do not like the lights. .

Later, there were some other RGB kits, and the price went up. The controllers still had to pick up 3 fans. .

Classic eclipse RGB suit, if there is no new out of the valley, I guess it will choose this

JONSBO Eclipse solar eclipse - RGB version 12CM chassis fan RGB fan three fan set (12CM/LED RGB 256 color light fan) 179 yuan Jingdong direct link

There are also a little bit of expensive RGB sets for the new light fans 331 and 231, and I'm waiting for the silk to feel a bit expensive. . .

JONSBO FR-231 12CM chassis fan RGB fan three fan set (LED RGB 256 color light fan / manual high speed and low speed switch) 259 yuan Jingdong direct link

JONSBO FR-331 12CM chassis fan RGB fan three fan set (LED RGB 256 color light fan / manual high speed and low speed switching) 259 yuan Jingdong direct link

Only when I see the protagonist of today. . . Xingu Moparty RGB fan kit, configuration is simply conscience

Light style can

The controller comes with a synchronous light effect, giving a magic stick can be flexible inside the chassis

Up to 8 fans can be connected plus 2 Aura light bars, which are almost ready to take off. . .

Can replace chassis control instead of control button

High and low 2 speed modes

Appearance Gallery

The outer box is an ordinary cardboard box, the texture is not bad

Simple introduction

On one side, there are three 6-pin fans. On the other side, it is an accessory. There is no other piece of paper. . .

↑ Accessories include a controller, a power cord, self-tapping screws, 4x4 bags, and a Velcro

Simply look at the controller

2Two 2Pin interfaces on the side, large connection power supply, small chassis, Reset

↑ Plug in the power cord to see Up and down symmetry each can be connected to a 4 light bar, 2 buttons are light effect switching and speed switching

Look at the 6pin fan interface and 4pin light bar interface

Next is the fan. The fan doesn't look at any parameters. . . Simply put, hydraulic bearings, 23DB operating noise

↑18 RGB lamp beads

Interface

Prepare for the machine

DB-S

Changzhou Changyuan Electronic Co., Ltd. , https://www.cydiode.com